NETGEAR ProSAFE M7100-24X - Show Ip Pim Ssm

PIM Mode
Interface
Interface-Mode
Operational-Sta
tus
IP Multicast Commands
335
ProSafe Managed Switch
Example 1:
(Switch) #show ip pim
PIM Mode Dense
Interface Interface-Mode Operational-Status
--------- -------------- ------------------
1/0/1 Enabled Operational
1/0/3 Disabled Non-Operational
Example 2:
(Switch) #show ip pim
PIM Mode Sparse
Interface Interface-Mode Operational-Status
--------- -------------- ------------------
1/0/1 Enabled Operational
1/0/3 Disabled Non-Operational
show ip pim ssm
This command shows the configured source specific IP multicast addresses.
Format show ip pim ssm
Mode
Group Address
Prefix Length
(Switch) #show ip pim ssm
Group Address/Prefix Length
----------------------------
232.0.0.0/8
Term Definition
Configured mode of PIM protocol (enabled or disabled).
Interface number.
Enable status of the interface.
Operational Status of the Interface.
Privileged EXEC
Term Definition
The address of the SSM Group.
Prefix Length of the SSM Group.