Utility Commands
564
ProSafe Managed Switch
no ip dhcp excluded-address
This command removes the excluded IP addresses for a DHCP client. Low-address and
high-address are valid IP addresses; each made up of four decimal bytes ranging from 0 to
255. IP address 0.0.0.0 is invalid.
Format no ip dhcp excluded-address <lowaddress> [highaddress]
Mode
ip dhcp ping packets
Use this command to specify the number, in a range from 2-10, of packets a DHCP server
sends to a pool address as part of a ping operation. By default the number of packets sent to
a pool address is 2, which is the smallest allowed number when sending packets. Setting the
number of packets to 0 disables this command.
Default
Format ip dhcp ping packets <0,2-10>
Mode
no ip dhcp ping packets
This command prevents the server from pinging pool addresses and sets the number of
packets to 0.
Default
Format no ip dhcp ping packets
Mode
service dhcp
This command enables the DHCP server.
Default
Format service dhcp
Mode
no service dhcp
This command disables the DHCP server.
Format no service dhcp
Mode
Global Config
2
Global Config
0
Global Config
disabled
Global Config
Global Config
To Next Page
Loading...
Need help?
General