NETGEAR ProSAFE M7100-24X - Ipv6 Router Ospf; Ipv6 Ospf Transmit-Delay; Area Default-Cost (Ospfv); Area Nssa (Ospfv)

IPv6 Commands
380
ProSafe Managed Switch
ipv6 ospf transmit-delay
This command sets the OSPF Transit Delay for the specified interface. The transmit delay is
specified in seconds. In addition, it sets the estimated number of seconds it takes to transmit
a link state update packet over this interface. Valid values for <seconds> range from 1 to
3600 (1 hour).
Default
Format ipv6 ospf transmit-delay
<seconds>
Mode
no ipv6 ospf transmit-delay
This command sets the default OSPF Transit Delay for the specified interface.
Format no ipv6 ospf transmit-delay
Mode
ipv6 router ospf
Use this command to enter Router OSPFv3 Config mode.
Format ipv6 router ospf
Mode
area default-cost (OSPFv3)
This command configures the monetary default cost for the stub area. The operator must
specify the area id and an integer value between 1–16777215.
Format area <areaid> default-cost <1-16777215>
Mode
area nssa (OSPFv3)
This command configures the specified areaid to function as an NSSA.
Format area <areaid> nssa
Mode
1
Interface Config
Interface Config
Global Config
Router OSPFv3 Config
Router OSPFv3 Config