Switching Commands
181
ProSafe Managed Switch
lldp med
Use this command to enable MED. By enabling MED, you will be effectively enabling the
transmit and receive function of LLDP.
Default
Format lldp med
Mode
no lldp med
Use this command to disable MED.
Format no lldp med
Mode
lldp med confignotification
Use this command to configure all the ports to send the topology change notification.
Default
Format lldp med confignotification
Mode
no ldp med confignotification
Use this command to disable notifications.
Format no lldp med confignotification
Mode
lldp med transmit-tlv
Use this command to specify which optional Type Length Values (TLVs) in the LLDP MED set
will be transmitted in the Link Layer Discovery Protocol Data Units (LLDPDUs).
Default
Format lldp med transmit-tlv [capabilities] [ex-pd] [ex-pse] [inventory]
[location] [network-policy]
Mode
enabled
Interface Config
Interface Config
enabled
Interface Config
Interface Config
By default, the capabilities and network policy TLVs are included.
Interface Config
Term Definition
capabilities
Transmit the LLDP capabilities TLV.
ex-pd
Transmit the LLDP extended PD TLV.
To Next Page
Loading...
Need help?
General