NETGEAR ProSAFE M7100-24X - Ip Ssh Protocol; Ip Ssh Server Enable; Sshcon Maxsessions

Management Commands
627
ProSafe Managed Switch
ip ssh
Use this command to enable SSH access to the system. (This command is the short form of
the ip ssh server enable command.)
Default
Format ip ssh
Mode
ip ssh protocol
Use this command to set or remove protocol levels (or versions) for SSH. Either SSH1 (1),
SSH2 (2), or both SSH 1 and SSH 2 (1 and 2) can be set.
Default
Format ip ssh protocol [1] [2]
Mode
ip ssh server enable
Use this command to enable the IP secure shell server.
Default
Format ip ssh server enable
Mode
no ip ssh server enable
Use this command to disable the IP secure shell server.
Format no ip ssh server enable
Mode
sshcon maxsessions
Use this command to specify the maximum number of SSH connection sessions that can be
established. A value of 0 indicates that no ssh connection can be established. The range is 0
to 5.
Default
Format sshcon maxsessions <0-5>
Mode
disabled
Privileged EXEC
1 and 2
Privileged EXEC
disabled
Privileged EXEC
Privileged EXEC
5
Privileged EXEC