Utility Commands
570
ProSafe Managed Switch
no ip domain name
Use this command to remove the default domain name configured using the ip domain
name command.
Format no ip domain name
Mode
ip domain list
Use this command to define a list of default domain names to complete unqualified names.
By default, the list is empty. Each name must be no more than 256 characters, and should
not include an initial period. The default domain name, configured using the ip domain
name command, is used only when the default domain name list is empty. A maximum of 32
names can be entered in to this list.
Default
Format ip domain list <name>
Mode
no ip domain list
Use this command to delete a name from a list.
Format no ip domain list <name>
Mode
ip name server
Use this command to configure the available name servers. Up to eight servers can be
defined in one command or by using multiple commands. The parameter
<server-address> is a valid IPv4 or IPv6 address of the server. The preference of the
servers is determined by the order they were entered.
Format ip name-server <server-address1> [server-address2...server-address8]
Mode
no ip name server
Use this command to remove a name server.
Format no ip name-server [server-address1...server-address8]
Mode
Global Config
none
Global Config
Global Config
Global Config
Global Config
To Next Page
Loading...
Need help?
General