EasyManuals Logo

NETGEAR ProSAFE M7100-24X User Manual

NETGEAR ProSAFE M7100-24X
776 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #225 background imageLoading...
Page #225 background image
Routing Commands
225
ProSafe Managed Switch
Mask of the interface. To remove all of the IP addresses (primary and secondary) configured
on the interface, enter the command no ip address.
Format no ip address [{<ipaddr> <subnetmask> [secondary]}]
Mode
ip address dhcp
Use this command to enable the DHCPv4 client on an in-band interface so that it can acquire
network information, such as the IP address, subnet mask, and default gateway from a
network DHCP server. When DHCP is enabled on the interface, the system automatically
deletes all manually configured IPv4 addresses on the interface.
Default
Format ip address dhcp
Mode
no ip address dhcp
Use this command to release a leased address and disable DHCPv4 on an interface.
Format no ip address dhcp
Mode
ip default-gateway
Use this command to manually configure a default gateway for the switch. Only one default
gateway can be configured. If you use this command multiple times, each command replaces
the previous value.
Format ip default-gateway <ipaddr>
Mode
no ip default-gateway
Use this command to remove the default gateway address from the configuration.
Format no ip default-gateway <ipaddr>
Mode
Interface Config
disabled
Interface Config
Interface Config
Global Config
Interface Config

Table of Contents

Other manuals for NETGEAR ProSAFE M7100-24X

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the NETGEAR ProSAFE M7100-24X and is the answer not in the manual?

NETGEAR ProSAFE M7100-24X Specifications

General IconGeneral
BrandNETGEAR
ModelProSAFE M7100-24X
CategorySwitch
LanguageEnglish

Related product manuals