Switching Commands
183
ProSafe Managed Switch
no lldp med confignotification all
Use this command to disable all the ports to send the topology change notification.
Format no lldp med confignotification all
Mode
lldp med faststartrepeatcount
Use this command to set the value of the fast start repeat count. [count] is the number of
LLDP PDUs that will be transmitted when the product is enabled. The range is 1 to 10.
Default
Format lldp med faststartrepeatcount [count]
Mode
no lldp med faststartrepeatcount
Use this command to return to the factory default value.
Format no lldp med faststartrepeatcount
Mode
lldp med transmit-tlv all
Use this command to specify which optional Type Length Values (TLVs) in the LLDP MED set
will be transmitted in the Link Layer Discovery Protocol Data Units (LLDPDUs).
Default
Format lldp med transmit-tlv all [capabilities] [ex-pd] [ex-pse] [inventory]
[location] [network-policy]
Mode
capabilities
ex-pd
ex-pse
inventory
location
network-policy
Global Config
3
Global Config
Global Config
By default, the capabilities and network policy TLVs are included.
Global Config
Term Definition
Transmit the LLDP capabilities TLV.
Transmit the LLDP extended PD TLV.
Transmit the LLDP extended PSE TLV.
Transmit the LLDP inventory TLV.
Transmit the LLDP location TLV.
Transmit the LLDP network policy TLV.
To Next Page
Loading...
Need help?
General