Captive Portal Commands
729
ProSafe Managed Switch
Captive Portal Configuration Commands
The commands in this section are related to captive portal configurations.
configuration (Captive Portal)
Use this command to enter the captive portal instance mode. The captive portal configuration
identified by CP ID 1 is the default CP configuration. The system supports a total of ten CP
configurations.
Format configuration <1-10>
Mode
no configuration
Use this command to delete a CP configuration. The default configuration cannot be deleted.
Format no configuration <1-10>
Mode
enable (Instance)
Use this command to enable a captive portal configuration.
Default
Format enable
Mode
no enable
Use this command to disable a configuration.
Default
Format no enable
Mode
name
Use this command to configure the name for a captive portal configuration. The cp-name can
be up to 32 alphanumeric characters in length.
Captive Portal Configuration mode
Captive Portal Configuration mode
enable
Captive Portal Instance mode
enable
Captive Portal Instance mode
Default
Configuration 1 has the name “Default” by default. All other configurations have no name
by default.
To Next Page
Loading...
Need help?
General