Routing Commands
272
ProSafe Managed Switch
no distance ospf
This command sets the default route preference value of OSPF routes in the router. The type
of OSPF can be intra, inter, or external. All the external type routes are given the same
preference value.
Format no distance ospf {intra-area | inter-area | external}
Mode
distribute-list out (OSPF)
Use this command to specify the access list to filter routes received from the source protocol.
Format distribute-list <1-199> out {rip | static | connected}
Mode
no distribute-list out
Use this command to specify the access list to filter routes received from the source protocol.
Format no distribute-list <1-199> out {rip | static | connected}
Mode
exit-overflow-interval (OSPF)
This command configures the exit overflow interval for OSPF. It describes the number of
seconds after entering overflow state that a router will wait before attempting to leave the
overflow state. This allows the router to again originate non-default AS-external-LSAs. When
set to 0, the router will not leave overflow state until restarted. The range for seconds is 0 to
2147483647 seconds.
Default
Format exit-overflow-interval <seconds>
Mode
no exit-overflow-interval
This command configures the default exit overflow interval for OSPF.
Format no exit-overflow-interval
Mode
Router OSPF Config
Router OSPF Config
Router OSPF Config
0
Router OSPF Config
Router OSPF Config
To Next Page
Loading...
Need help?
General