IPv6 Commands
377
ProSafe Managed Switch
ipv6 ospf cost
This command configures the cost on an OSPF interface. The <cost> parameter has a
range of 1 to 65535.
Default
Format ipv6 ospf cost <1-65535>
Mode
no ipv6 ospf cost
This command configures the default cost on an OSPF interface.
Format no ipv6 ospf cost
Mode
ipv6 ospf dead-interval
This command sets the OSPF dead interval for the specified interface. The value for
<seconds> is a valid positive integer, which represents the length of time in seconds that a
router's Hello packets have not been seen before its neighbor routers declare that the router
is down. The value for the length of time must be the same for all routers attached to a
common network. This value should be some multiple of the Hello Interval (i.e., 4). Valid
values range for <seconds> is from 1 to 2147483647.
Default
Format ipv6 ospf dead-interval <seconds>
Mode
no ipv6 ospf dead-interval
This command sets the default OSPF dead interval for the specified interface.
Format no ipv6 ospf dead-interval
Mode
ipv6 ospf hello-interval
This command sets the OSPF hello interval for the specified interface. The value for
<seconds> is a valid positive integer, which represents the length of time in seconds. The
value for the length of time must be the same for all routers attached to a network. Valid
values for <seconds> range from 1 to 65535.
10
Interface Config
Interface Config
40
Interface Config
Interface Config
Default
10
To Next Page
Loading...
Need help?
General