Switching Commands
73
ProSafe Managed Switch
no set gvrp adminmode
This command disables GVRP.
Format no set gvrp adminmode
Mode
set gvrp interfacemode
This command enables GVRP on a single port (Interface Config mode) or all ports (Global
Config mode).
Default
Format set gvrp interfacemode
Mode
• Interface Config
• Global Config
no set gvrp interfacemode
This command disables GVRP on a single port (Interface Config mode) or all ports (Global
Config mode). If GVRP is disabled, Join Time, Leave Time and Leave All Time have no
effect.
Format no set gvrp interfacemode
Mode
• Interface Config
• Global Config
show gvrp configuration
This command displays Generic Attributes Registration Protocol (GARP) information for one
or all interfaces.
Format show gvrp configuration {<unit/slot/port> | all}
Mode
• Privileged EXEC
• User EXEC
Privileged EXEC
disabled
Term Definition
Interface
Valid slot and port number separated by forward slashes.
Join Timer
The interval between the transmission of GARP PDUs registering (or re-registering)
membership for an attribute. Current attributes are a VLAN or multicast group. There is
an instance of this timer on a per-Port, per-GARP participant basis. Permissible values
are 10 to 100 centiseconds (0.1 to 1.0 seconds). The factory default is 20 centiseconds
(0.2 seconds). The finest granularity of specification is one centisecond (0.01 seconds).
To Next Page
Loading...
Need help?
General