NETGEAR ProSAFE M7100-24X - Stacking

Log Messages
720
ProSafe Managed Switch
Stacking
Table 51. PIM-DM Log Messages
Component Message Cause
PIM-DM
Out of memory when creating xxx This message is logged when there is
insufficient memory to accommodate a new
neighbor/(S,G) Entry, Prune, Graft, Join
etc.
PIM-DM
Error entry->ll_xxx LL creation error This message is logged when the SLL
creation is Failed.
PIM-DM
pim_interface_set: Could not give
taskSema
This message is logged when Task
synchronization Semaphore release fails.
PIM-DM
Error initializing CACHE This message is logged when the PIM-DM
(S,G) entry Cache table initialization fails.
PIM-DM
Error creating PIM-DM pipe This message is logged when the PIM-DM
Pipe (that receives control messages)
creation fails.
Table 52. DVMRP Log Messages
Component Message Cause
DVMRP
dvmrp_send_graft: failed getting memory
for graft
Failed to allocate memory while sending a
graft
DVMRP
dvmrp_register_neighbor: failed getting
memory for nbr
Failed to allocate memory while registering
a neighbor
DVMRP
dvmrp_recv_prune: failed getting memory
for prune
Failed to allocate memory while receiving a
prune
DVMRP
dvmrp_new_route: failed getting memory
for route
Failed to get memory for a new route entry
DVMRP
dvmrp_prepare_routes: failed getting
memory for dvmrp_ann_rt
Failed to get memory while announcing a
new route entry
Table 53. EDB Log Message
Component Message Cause
EDB
EDB Callback: Unit Join: <num>. Unit <num> has joined the stack.