NETGEAR ProSAFE M7100-24X - Serial Timeout; Login Authentication

Management Commands
620
ProSafe Managed Switch
no serial baudrate
Use this command to set the communication rate of the terminal interface.
Format no serial baudrate
Mode
serial timeout
Use this command to specify the maximum connect time (in minutes) without console activity.
A value of 0 indicates that a console can be connected indefinitely. The time range is 0 to
160.
Default
Format serial timeout <0-160>
Mode
no serial timeout
Use this command to set the maximum connect time (in minutes) without console activity.
Format no serial timeout
Mode
login authentication
Use this command in line configuration mode to specify a login authentication method list for
remote telnet or console.
Format login authentication {default | list-name}
Mode
no login authentication
Use this command to return to the default specified by the
login authentication
command.
Format no login authentication {default | list-name}
Mode
Line Config
5
Line Config
Line Config
Line Config
Line Config