NETGEAR ProSAFE M7100-24X User Manual

Switching Commands
199
ProSafe Managed Switch
show dos-control
This command displays Denial of Service configuration information.
Format show dos-control
Mode
Note: Not all messages below are available in all 7000series managed
switches.
Privileged EXEC
Term Definition
First Fragment
Mode
May be enabled or disabled. The factory default is disabled.
Min TCP Hdr
Size <0-255>
The factory default is 20.
ICMP Mode
May be enabled or disabled. The factory default is disabled.
Max ICMPv4 Pkt
Size
The range is 0-1023. The factory default is 512.
Max ICMPv6 Pkt
Size
The range is 0-16384. The factory default is 512.
ICMP Fragment
Mode
May be enabled or disabled. The factory default is disabled.
L4 Port Mode
May be enabled or disabled. The factory default is disabled.
TCP Port Mode
May be enabled or disabled. The factory default is disabled.
UDP Port Mode
May be enabled or disabled. The factory default is disabled.
SIPDIP Mode
May be enabled or disabled. The factory default is disabled.
SMACDMAC
Mode
May be enabled or disabled. The factory default is disabled.
TCP Flag Mode
May be enabled or disabled. The factory default is disabled.
TCP FIN&URG&
PSH Mode
May be enabled or disabled. The factory default is disabled.
TCP Flag &
Sequence Mode
May be enabled or disabled. The factory default is disabled.
TCP SYN Mode
May be enabled or disabled. The factory default is disabled.
TCP SYN & FIN
Mode
May be enabled or disabled. The factory default is disabled.
TCP Fragment
Mode
May be enabled or disabled. The factory default is disabled.
TCP Offset
Mode
May be enabled or disabled. The factory default is disabled.

NETGEAR ProSAFE M7100-24X Specifications

General

Brand	NETGEAR
Model	ProSAFE M7100-24X
Category	Switch
Language	English