Switching Commands
165
ProSafe Managed Switch
set mld querier
Use this command to enable MLD Snooping Querier on the system (Global Config Mode) or
on a VLAN. Using this command, you can specify the IP address that the snooping querier
switch should use as a source address while generating periodic queries.
If a VLAN has MLD Snooping Querier enabled and MLD Snooping is operationally disabled
on it, MLD Snooping Querier functionality is disabled on that VLAN. MLD Snooping
functionality is re-enabled if MLD Snooping is operational on the VLAN.
The MLD Snooping Querier sends periodic general queries on the VLAN to solicit
membership reports.
• Global Config
• VLAN Mode
no set mld querier
Use this command to disable MLD Snooping Querier on the system. Use the optional
parameter address to reset the querier address.
no set mld querier [vlan-id][address]
• Global Config
• VLAN Mode
set mld querier query_interval
Use this command to set the MLD Querier Query Interval time. This is the amount of time in
seconds that the switch waits before sending another general query.
no set mld querier query_interval
Use this command to set the MLD Querier Query Interval time to its default value.
Default disabled
Format set mld querier [vlan-id] [address ipv6_address]
Mode
Format
Mode
Default disabled
Format set mld querier query_interval <1-18000>
Mode Global Config
Format no set mld querier query_interval
Mode Global Config
To Next Page
Loading...
Need help?
General