Switching Commands
107
ProSafe Managed Switch
Note: This command is only applicable to physical interfaces.
no lacp actor admin state longtimeout
Use this command to set the LACP actor admin state to short timeout.
Format no lacp actor admin state longtimeout
Mode
Note: This command is only applicable to physical interfaces.
lacp actor admin state passive
Use this command to set the LACP actor admin state to passive.
Format lacp actor admin state passive
Mode
Note: This command is only applicable to physical interfaces.
no lacp actor admin state passive
Use this command to set the LACP actor admin state to active.
Format no lacp actor admin state passive
Mode
lacp actor port priority
Use this command to configure the priority value assigned to the Aggregation Port. The valid
range for <priority> is 0 to 255.
Default
Format lacp actor port priority <priority>
Mode
Note: This command is only applicable to physical interfaces.
Interface Config
Interface Config
Interface Config
0x80
Interface Config
To Next Page
Loading...
Need help?
General