NETGEAR ProSAFE M7100-24X - Auto-Negotiate All

Switching Commands
22
ProSafe Managed Switch
Note: The IP address cannot be assigned to a LAG virtual interface. The
interface must be put under a VLAN group and an IP address
assigned to the VLAN group.
auto-negotiate
This command enables automatic negotiation on a port.
Default
Format auto-negotiate
Mode
no auto-negotiate
This command disables automatic negotiation on a port.
Note: Automatic sensing is disabled when automatic negotiation is
disabled.
auto-negotiate all
This command enables automatic negotiation on all ports.
Default
Format auto-negotiate all
Mode
no auto-negotiate all
This command disables automatic negotiation on all ports.
Format no auto-negotiate all
Mode
Format interface lag <lag id>
Mode
Global Config
enabled
Interface Config
enabled
Global Config
Global Config