NETGEAR ProSAFE M7100-24X User Manual

Switching Commands
134
ProSafe Managed Switch
no ip dhcp snooping log-invalid
Use this command to disable the logging DHCP messages filtration by the DHCP Snooping
application.
Format no ip dhcp snooping log-invalid
Mode
ip dhcp snooping trust
Use this command to configure the port as trusted.
Default
Format ip dhcp snooping trust
Mode
no ip dhcp snooping trust
Use this command to configure the port as untrusted.
Format no ip dhcp snooping trust
Mode
ip verify source
Use this command to configure the IPSG source ID attribute to filter the data traffic in the
hardware. Source ID is the combination of IP address and MAC address. Normal command
allows data traffic filtration based on the IP address. With the “port-security” option, the data
traffic will be filtered based on the IP and MAC addresses.
Default the source ID is the IP address
Format ip verify source {port-security}
Mode
no ip verify source
Use this command to disable the IPSG configuration in the hardware. You cannot disable
port-security alone if it is configured.
Format no ip verify source
Mode
Interface Config
disabled
Interface Config
Interface Config
Interface Config
Interface Config

NETGEAR ProSAFE M7100-24X Specifications

General

Brand	NETGEAR
Model	ProSAFE M7100-24X
Category	Switch
Language	English