NETGEAR ProSAFE M7100-24X - Page 185

Switching Commands
185
ProSafe Managed Switch
Example: The following shows example CLI display output for the command.
(Switch) #show lldp med interface all
Interface Link configMED operMED ConfigNotify TLVsTx
--------- ------ --------- -------- ------------ -----------
1/0/1 Down Disabled Disabled Disabled 0,1
1/0/2 Up Disabled Disabled Disabled 0,1
1/0/3 Down Disabled Disabled Disabled 0,1
1/0/4 Down Disabled Disabled Disabled 0,1
1/0/5 Down Disabled Disabled Disabled 0,1
1/0/6 Down Disabled Disabled Disabled 0,1
1/0/7 Down Disabled Disabled Disabled 0,1
1/0/8 Down Disabled Disabled Disabled 0,1
1/0/9 Down Disabled Disabled Disabled 0,1
1/0/10 Down Disabled Disabled Disabled 0,1
1/0/11 Down Disabled Disabled Disabled 0,1
1/0/12 Down Disabled Disabled Disabled 0,1
1/0/13 Down Disabled Disabled Disabled 0,1
1/0/14 Down Disabled Disabled Disabled 0,1
TLV Codes: 0- Capabilities, 1- Network Policy
2- Location, 3- Extended PSE
4- Extended Pd, 5- Inventory
--More-- or (q)uit
(Switch) #show lldp med interface 1/0/2
Interface Link configMED operMED ConfigNotify TLVsTx
--------- ------ --------- -------- ------------ -----------
1/0/2 Up Disabled Disabled Disabled 0,1
TLV Codes: 0- Capabilities, 1- Network Policy
2- Location, 3- Extended PSE
4- Extended Pd, 5- Inventory
(Routing) #
Term Definition
Interface
The interface in a unit/slot/port format.
Link
Shows whether the link is up or down.
ConfigMED
Shows if the LLPD-MED mode is enabled or disabled on this interface
OperMED
Shows if the LLPD-MED TLVs are transmitted or not on this interface.
ConfigNotify
Shows if the LLPD-MED topology notification mode of this interface.
TLVsTx
Shows whether the interface sends optional TLVs in the LLDPDUs. The TLV codes
can be 0 (Capabilities), 1 (Network Policy), 2 (Location), 3 (Extended PSE), 4
(Extended Pd), or 5 (Inventory).