Siemens sinamics dcp - p3135 Suppress active fault; Supp act flt; p3950 Service parameter; Serv par; r3974 Drive unit status word; Drv_unit ZSW; r3977 BICO counter topology; BICO counter topo

2 Parameters
2.2 List of parameters
SINAMICS DCP
122 List Manual (LH21), 05/2016
Description: Sets the suppression of r2139.3 "Fault present" for certain fault responses.
Dependency: Refer to: r2139
Note: Depending on the suppression of a fault reaction in this parameter, r2139.1 "Acknowledgement required" is set when
at least one fault occurs.
Re bit 08:
The suppression is only effective if p0491 = 1.
Description: For service personnel only.
Description: Displays the status word for the drive unit.
Description: Displays the BICO interconnections that have been parameterized in the complete (overall) topology.
The counter is incremented by one for each modified BICO interconnection.
Dependency: Refer to: r3978, r3979
Description: Displays the counter reading for modified BICO interconnections on this device.
The counter is incremented by one for each modified BICO interconnection.
p3135 Suppress active fault / Supp act flt
DCP_CTRL Can be changed: U, T Access level: 4
Data type: Unsigned32 Func. diagram: 8060
Min Max Factory setting
- - 0000 0000 0000 0000 bin
Bit field: Bit Signal name 1 signal 0 signal FP
08 Suppression of fault response ENCODER ON OFF -
10 Suppression of fault response NONE ON OFF -
p3950 Service parameter / Serv par
CU_DCP Can be changed: C1, U, T Access level: 3
Data type: Unsigned16 Func. diagram: -
Min Max Factory setting
- - -
r3974 Drive unit status word / Drv_unit ZSW
CU_DCP Can be changed: - Access level: 1
Data type: Unsigned32 Func. diagram: -
Min Max Factory setting
- - -
Bit field: Bit Signal name 1 signal 0 signal FP
00 Software reset active Yes No -
01 Writing of parameters disabled as
parameter save in progress
Yes No -
02 Writing of parameters disabled as macro is
running
Yes No -
r3977 BICO counter topology / BICO counter topo
CU_DCP Can be changed: - Access level: 4
Data type: Unsigned32 Func. diagram: -
Min Max Factory setting
- - -
r3978 BICO CounterDevice / BICO CounterDevice
CU_DCP Can be changed: - Access level: 4
Data type: Unsigned32 Func. diagram: -
Min Max Factory setting
- - -