Siemens sinamics dcp - Fig. 3-22 2650 - Sequencer

SINAMICS DCP List Manual (LH21), 05/2016
339
3 Function diagrams
3.6 Sequence control
Fig. 3-22 2650 – Sequencer
fp_2650_89.vsd
12345678
- 2650 -
SINAMICS DCP
25.04.2016 v 1.2
DO: DCP_CTRL
- Sequencer
Function diagram
AUS 2=1
Enable ramp-function generator,
speed generator, Ia controller
OFF 1 = 0
Operating enable=1Operating enable=0
Fault
acknowledgement
[2546.7]
OFF 2=1
OFF 3=1
and
n=0
OFF 1 = 0
OFF 1 = 1
OFF 3 = 0
OFF 2 = 0
16,000 μs
[1020.7]
Note 1: Statuses S1 to S5 are defined
in PROFIdrive profile V4.1
Note 2: "p.e." means "pulses enabled"
S1 : Switching On Inhibited S1 : Switching On Inhibited
S1 : Switching On Inhibited
S2: Ready For Switching On
S1 : Switching On Inhibited
S1 : Switching On Inhibited
S3: Switched On
S4: Operation
Voltage-
enable
Voltage-
enable
Voltage-
enable
OFF 2 = 0
OFF 3 = 0
Fault
Drv op_display
r00002
Op_display
r50000
Fault add info
r50047
Fault handling
Control of
operating state
r52800
Seq_ctr op_state
+
r50001
Seq_ctrl quad_dis
+
Siemens Parts