Siemens sinamics dcp - r8849[0...139] COMM BOARD receive configuration data; CB r config_dat; r8850[0...4] CO: IF2 PZD receive word; IF2 PZD recv word; p8851[0...63] CI: IF2 PZD send word; IF2 PZD send word

SINAMICS DCP
List Manual (LH21), 05/2016
195
2 Parameters
2.2 List of parameters
Note: The system only permits certain sampling times and after writing to this parameter, displays the value that has
actually been set.
For clock cycle synchronous operation, the specified bus cycle time applies (Tdp).
Description: Displays the receive configuration data for the COMM BOARD.
Description: Connector output for interconnecting the PZD (setpoints) received via interface 2 in the word format.
Index: [0] = PZD 1
[1] = PZD 2
[2] = PZD 3
[3] = PZD 4
[4] = PZD 5
Note: IF2: Interface 2
PZD1 to PZD2 are displayed bit-serially in r8890 to r8891.
Description: Selects the PZD (actual values) to be sent via interface 2 in the word format.
Index: [0] = PZD 1
[1] = PZD 2
[2] = PZD 3
[3] = PZD 4
[4] = PZD 5
[5] = PZD 6
[6] = PZD 7
[7] = PZD 8
[8] = PZD 9
[9] = PZD 10
[10] = PZD 11
[11] = PZD 12
[12] = PZD 13
[13] = PZD 14
[14] = PZD 15
[15] = PZD 16
[16] = PZD 17
[17] = PZD 18
[18] = PZD 19
[19] = PZD 20
[20] = PZD 21
[21] = PZD 22
[22] = PZD 23
[23] = PZD 24
[24] = PZD 25
[25] = PZD 26
[26] = PZD 27
[27] = PZD 28
r8849[0...139] COMM BOARD receive configuration data / CB r config_dat
CU_DCP (PROFINET
CBE20)
Can be changed: - Access level: 3
Data type: Unsigned16 Func. diagram: -
Min Max Factory setting
- - -
r8850[0...4] CO: IF2 PZD receive word / IF2 PZD recv word
TM150, TM15DI_DO,
TM31
Can be changed: - Access level: 3
Data type: Integer16 Func. diagram: 2491
Min Max Factory setting
- - -
p8851[0...63] CI: IF2 PZD send word / IF2 PZD send word
DCP_CTRL Can be changed: U, T Access level: 3
Data type: Unsigned32 / Integer16 Func. diagram: 2487, 9208
Min Max Factory setting
- - 0
Siemens Parts