Siemens sinamics dcp - p4813 Function generator physical address reference value; FG phys addr ref; p4816 Function generator output signal integer number scaling; FG outp integ scal; r4817 CO: Function generator output signal integer number; FG outp integ no.; r4818 CO: Function generator output signal; FG outp_sig

SINAMICS DCP
List Manual (LH21), 05/2016
177
2 Parameters
2.2 List of parameters
Description: Sets the reference value for 100 % for referred inputs.
Dependency: Only effective when p4810 = 99.
Description: Sets the scaling for the integer number of the output signal for the function generator.
Dependency: Refer to: r4805, r4817
Note: The parameter can only be changed in the following operating states:
r4805 = 0, 4, 6
Description: Display and connector output for the integer number of the output signal for the function generator.
Dependency: Refer to: p4816
Note: The value is output independent of the function generator operating mode.
Description: Displays the output signal for the function generator.
Dependency: Refer to: p4810
Note: The value is displayed independently of the function generator mode.
Description: Sets the signal source to control the function generator.
When the function generator is running, signal generation is stopped with a 0 signal from BI: p4819 and p4800 is set
to 0.
Dependency: Refer to: p4800
Description: Sets the signal to be generated for the function generator.
p4813 Function generator physical address reference value / FG phys addr ref
CU_DCP Can be changed: U, T Access level: 3
Data type: FloatingPoint32 Func. diagram: -
Min Max Factory setting
1.00 1000000.00 1.00
p4816 Function generator output signal integer number scaling / FG outp integ scal
CU_DCP Can be changed: U, T Access level: 4
Data type: Integer32 Func. diagram: -
Min Max Factory setting
-2147483648 2147483647 0
r4817 CO: Function generator output signal integer number / FG outp integ no.
CU_DCP Can be changed: - Access level: 4
Data type: Integer32 Func. diagram: -
Min Max Factory setting
- - -
r4818 CO: Function generator output signal / FG outp_sig
CU_DCP Can be changed: - Access level: 3
Data type: FloatingPoint32 Func. diagram: -
Min Max Factory setting
- [%] - [%] - [%]
p4819 BI: Function generator control / FG control
CU_DCP Can be changed: U, T Access level: 3
Data type: Unsigned32 / Binary Func. diagram: -
Min Max Factory setting
- - 1
p4820 Function generator signal shape / FG signal shape
CU_DCP Can be changed: U, T Access level: 3
Data type: Integer16 Func. diagram: -
Min Max Factory setting
1 5 1
Siemens Parts