2 Parameters
2.2 List of parameters
SINAMICS DCP
254 List Manual (LH21), 05/2016
Description: Sets the signal source for digital output 2 (DO 2, X177.21) on the CUD.
Note: DO: Digital Output
Description: Sets the signal source for digital output 3 (DO 3, X177.22) on the CUD.
Note: DO: Digital Output
Description: Sets the delay time for digital output 0 (DO 0, X177.19) on the CUD.
Note: DO: Digital Output
Description: Sets the delay time for digital output 1 (DO 1, X177.20) on the CUD.
Note: DO: Digital Output
Description: Sets the delay time for digital output 2 (DO 2, X177.21) on the CUD.
Note: DO: Digital Output
Description: Sets the delay time for digital output 3 (DO 3, X177.22) on the CUD.
Note: DO: Digital Output
p50773 BI: CUD digital output 2 signal source / CUD DO 2 s_src
DCP_CTRL Can be changed: U, T Access level: 3
Data type: Unsigned32 / Binary Func. diagram: 2055
Min Max Factory setting
- - 0
p50774 BI: CUD digital output 3 signal source / CUD DO 3 s_src
DCP_CTRL Can be changed: U, T Access level: 3
Data type: Unsigned32 / Binary Func. diagram: 2055
Min Max Factory setting
- - 0
p50775 CUD digital output 0 delay time / CUD DO 0 t_del
DCP_CTRL Can be changed: U, T Access level: 3
Data type: FloatingPoint32 Func. diagram: 2055
Min Max Factory setting
0 [ms] 10000 [ms] 0 [ms]
p50776 CUD digital output 1 delay time / CUD DO 1 t_del
DCP_CTRL Can be changed: U, T Access level: 3
Data type: FloatingPoint32 Func. diagram: 2055
Min Max Factory setting
0 [ms] 10000 [ms] 0 [ms]
p50777 CUD digital output 2 delay time / CUD DO 2 t_del
DCP_CTRL Can be changed: U, T Access level: 3
Data type: FloatingPoint32 Func. diagram: 2055
Min Max Factory setting
0 [ms] 10000 [ms] 0 [ms]
p50778 CUD digital output 3 delay time / CUD DO 3 t_del
DCP_CTRL Can be changed: U, T Access level: 3
Data type: FloatingPoint32 Func. diagram: 2055
Min Max Factory setting
0 [ms] 10000 [ms] 0 [ms]
To Next Page
Loading...
