2 Parameters
2.2 List of parameters
SINAMICS DCP
174 List Manual (LH21), 05/2016
Description: Sets the physical address for the trigger signal.
The data type is defined by making the appropriate selection in p4711.
Index: [0] = Trace 0
[1] = Trace 1
Description: Displays the recorded data type 5 for the trace.
Index: [0] = Trace 0
[1] = Trace 1
Description: Displays the recorded data type 6 for the trace.
Index: [0] = Trace 0
[1] = Trace 1
Description: Displays the recorded data type 7 for the trace.
Index: [0] = Trace 0
[1] = Trace 1
Description: Displays the recorded data type 8 for the trace.
Index: [0] = Trace 0
[1] = Trace 1
Description: Changes over the memory bank to read out the contents of the trace buffer.
Dependency: Refer to: r4740, r4741, r4742, r4743, r4750, r4751, r4752, r4753
p4789[0...1] Trace physical address trigger signal / Trace PhyAddr Trig
CU_DCP Can be changed: U, T Access level: 3
Data type: Unsigned32 Func. diagram: -
Min Max Factory setting
0000 hex FFFF FFFF hex 0000 hex
r4790[0...1] Trace data type 5 traced / Trace rec type 5
CU_DCP Can be changed: - Access level: 3
Data type: Unsigned32 Func. diagram: -
Min Max Factory setting
- - -
r4791[0...1] Trace data type 6 traced / Trace rec type 6
CU_DCP Can be changed: - Access level: 3
Data type: Unsigned32 Func. diagram: -
Min Max Factory setting
- - -
r4792[0...1] Trace data type 7 traced / Trace rec type 7
CU_DCP Can be changed: - Access level: 3
Data type: Unsigned32 Func. diagram: -
Min Max Factory setting
- - -
r4793[0...1] Trace data type 8 traced / Trace rec type 8
CU_DCP Can be changed: - Access level: 3
Data type: Unsigned32 Func. diagram: -
Min Max Factory setting
- - -
p4795 Trace memory bank changeover / Trace mem changeov
CU_DCP Can be changed: U, T Access level: 3
Data type: Unsigned32 Func. diagram: -
Min Max Factory setting
0 500 0
To Next Page
Loading...
