Siemens sinamics dcp - r2054 PROFIBUS status; PB status; r2055[0...2] PROFIBUS diagnostics standard; PB diag standard; r2060[0...62] CO: IF1 PROFIdrive PZD receive double word; IF1 PZD recv DW

2 Parameters
2.2 List of parameters
SINAMICS DCP
74 List Manual (LH21), 05/2016
Note: IF1: Interface 1
Description: Status display for the PROFIBUS interface.
Value: 0: OFF
1: No connection (search for baud rate)
2: Connection OK (baud rate found)
3: Cyclic connection with master (data exchange)
4: Cyclic data OK
Note: Re r2054 = 3:
In state 3 (the LED flashes green), a cyclic connection has been established to the PROFIBUS master; however, one
of the following prerequisites is missing for cyclic operation:
- No setpoints are being received as the PROFIBUS master is in the STOP condition.
Only for clock-cycle synchronous operation, the following applies:
- The drive is not in synchronism as the global control (GC) has an error.
Re r2054 = 4:
In the status 4 (LED green), the cyclic connection to the PROFIBUS master has been established and setpoints are
being received. The clock cycle synchronization is OK, the global control (GC) is error-free.
This state does not provide any statement regarding the quality of the clock cycle synchronous sign-of-life characters
on the drive objects.
Description: Diagnostics display for the PROFIBUS interface.
Index: [0] = Master bus address
[1] = Master input total length bytes
[2] = Master output total length bytes
Description: Connector output to interconnect PZD (setpoints) with double word format received from the fieldbus controller.
Index: [0] = PZD 1 + 2
[1] = PZD 2 + 3
[2] = PZD 3 + 4
[3] = PZD 4 + 5
[4] = PZD 5 + 6
[5] = PZD 6 + 7
[6] = PZD 7 + 8
[7] = PZD 8 + 9
07 Bit 7 ON OFF -
08 Bit 8 ON OFF -
09 Bit 9 ON OFF -
10 Bit 10 ON OFF -
11 Bit 11 ON OFF -
12 Bit 12 ON OFF -
13 Bit 13 ON OFF -
14 Bit 14 ON OFF -
15 Bit 15 ON OFF -
r2054 PROFIBUS status / PB status
CU_DCP Can be changed: - Access level: 3
Data type: Integer16 Func. diagram: 2410
Min Max Factory setting
0 4 -
r2055[0...2] PROFIBUS diagnostics standard / PB diag standard
CU_DCP Can be changed: - Access level: 3
Data type: Unsigned16 Func. diagram: 2410
Min Max Factory setting
- - -
r2060[0...62] CO: IF1 PROFIdrive PZD receive double word / IF1 PZD recv DW
DCP_CTRL Can be changed: - Access level: 3
Data type: Integer32 Func. diagram: 2440, 2460
Min Max Factory setting
- - -