Siemens sinamics dcp - Fig. 3-51 8075 - Fault;alarm configuration

SINAMICS DCP List Manual (LH21), 05/2016
373
3 Function diagrams
3.11 Faults and alarms
Fig. 3-51 8075 – Fault/alarm configuration
fp_8075_89.vsd
12345678
- 8075 -
SINAMICS DCP
03.06.2014 v 1.2
DO: All Objects
- Fault/alarm configuration
Function diagram
[0]
[1]
[19]
[0]
[1]
[19]
[0]
[1]
[19]
[0]
[1]
[19]
[0]
[1]
[19]
[0]
[1]
[19]
Background
[1020.7]
<1>
<1>
<1>
<1>
p02100
p02101 p02118 p02119
p02126 p02127
0 = NONE
1 = OFF1
2 = OFF2
3 = OFF3
reserved
reserved
reserved
reserved
1 = Fault
2 = Alarm
3 = No message
1 = Acknowledgement only using POWER ON.
2 = IMMEDIATE acknowledgment after removal of fault cause.
3 = Acknowledgement only for PULSE INHIBIT
Change fault reaction for a maximum of 20 faults
Change acknowledge mode for a maximum of 20 faults
Change fault message type <==> Alarm for a maximum of 20 faults/alarms
0. Fault code
1. Fault code
19. Fault code
Fault reaction
Fault reaction
Fault reaction
0. Fault code
1. Fault code
19. Fault code
Acknowledge mode
Acknowledge mode
Acknowledge mode
0. Fault/alarm code
1. Fault/alarm code
19. Fault/alarm code
Fault/alarm type
Fault/alarm type
Fault/alarm type
With the factory settings, the fault reaction, acknowledge mode, and message type are preassigned in a meaningful way for all faults and alarms.
Any changes can only be made in one individual value range, specified by SIEMENS, in each case.
When changes
Siemens Parts