2 Parameters
2.2 List of parameters
SINAMICS DCP
42 List Manual (LH21), 05/2016
Description: Displays the bootloader version.
Index 0:
Displays the bootloader version.
Index 1:
Displays the bootloader version 3 (for CU320-2 and CU310-2)
Value 0 means that boot loader 3 is not available.
Dependency: Refer to: r0018, r0158, r0198
Note: Example:
The value 1010100 should be interpreted as V01.01.01.00.
Description: Displays the BIOS and EEPROM data version.
r0198[0]: BIOS version
r0198[1]: EEPROM data version EEPROM 0
r0198[2]: EEPROM data version EEPROM 1
Dependency: Refer to: r0018, r0158, r0197
Note: Example:
The value 1010100 should be interpreted as V01.01.01.00.
Description: Freely assignable name for a drive object.
In the commissioning software, this name cannot be entered using the expert list, but is specified in the configuration
assistant. The object name can be subsequently modified in the Project Navigator using standard Windows
resources.
Note: The parameter is not influenced by setting the factory setting.
Description: Displays the name of the firmware package on the memory card/device memory.
r0203[0]: Name character 1
...
r0203[15]: Name character 16
For the commissioning software, the ASCII characters are displayed uncoded.
Notice: An ASCII table (excerpt) can be found, for example, in the appendix to the List Manual.
r0197[0...1] Bootloader version / Bootloader vers
CU_DCP Can be changed: - Access level: 4
Data type: Unsigned32 Func. diagram: -
Min Max Factory setting
- - -
r0198[0...2] BIOS/EEPROM data version / BIOS/EEPROM vers
CU_DCP Can be changed: - Access level: 4
Data type: Unsigned32 Func. diagram: -
Min Max Factory setting
- - -
p0199[0...24] Drive object name / DO name
All objects Can be changed: C1 Access level: 2
Data type: Unsigned16 Func. diagram: -
Min Max Factory setting
0 65535 0
r0203[0...15] Firmware package name / FW pkg name
CU_DCP Can be changed: - Access level: 4
Data type: Unsigned8 Func. diagram: -
Min Max Factory setting
- - -
To Next Page
Loading...
