Siemens sinamics dcp - r2076[0...4] IF1 PROFIdrive diagnostics telegram offset PZD send; IF1 diag offs send; r2077[0...15] PROFIBUS diagnostics peer-to-peer data transfer addresses; PB diag peer addr; p2079 IF1 PROFIdrive PZD telegram selection extended; IF1 PZD telegr ext

SINAMICS DCP
List Manual (LH21), 05/2016
85
2 Parameters
2.2 List of parameters
[46] = PZD 47
[47] = PZD 48
[48] = PZD 49
[49] = PZD 50
[50] = PZD 51
[51] = PZD 52
[52] = PZD 53
[53] = PZD 54
[54] = PZD 55
[55] = PZD 56
[56] = PZD 57
[57] = PZD 58
[58] = PZD 59
[59] = PZD 60
[60] = PZD 61
[61] = PZD 62
[62] = PZD 63
[63] = PZD 64
Note: IF1: Interface 1
Value range:
0 - 242: Byte offset
65535: Not assigned
Description: Displays the PZD byte offset in the PROFIdrive send telegram (controller input).
Index: [0] = PZD 1
[1] = PZD 2
[2] = PZD 3
[3] = PZD 4
[4] = PZD 5
Note: IF1: Interface 1
Value range:
0 - 242: Byte offset
65535: Not assigned
Description: Displays the addresses of the slaves (peers) where peer-to-peer data transfer has been configured via PROFIBUS.
Description: Sets the send and receive telegram.
Contrary to p0922, a telegram can be selected using p2079 and subsequently expanded.
Value: 390: SIEMENS telegram 390, PZD-2/2
391: SIEMENS telegram 391, PZD-3/7
392: SIEMENS telegram 392, PZD-3/15
393: SIEMENS telegram 393, PZD-4/21
394: SIEMENS telegram 394, PZD-3/3
r2076[0...4] IF1 PROFIdrive diagnostics telegram offset PZD send / IF1 diag offs send
TM150, TM15DI_DO,
TM31
Can be changed: - Access level: 3
Data type: Unsigned16 Func. diagram: 2410
Min Max Factory setting
- - -
r2077[0...15] PROFIBUS diagnostics peer-to-peer data transfer addresses / PB diag peer addr
CU_DCP Can be changed: - Access level: 3
Data type: Unsigned8 Func. diagram: -
Min Max Factory setting
- - -
p2079 IF1 PROFIdrive PZD telegram selection extended / IF1 PZD telegr ext
CU_DCP Can be changed: T Access level: 3
Data type: Integer16 Func. diagram: -
Min Max Factory setting
390 999 999
Siemens Parts