SINAMICS DCP
List Manual (LH21), 05/2016
69
2 Parameters
2.2 List of parameters
[57] = PZD 58
[58] = PZD 59
[59] = PZD 60
[60] = PZD 61
[61] = PZD 62
[62] = PZD 63
[63] = PZD 64
Dependency: Refer to: r2060
Notice: Where there is a multiple interconnection of a connector output, all the connector inputs must either have Integer or
FloatingPoint data types.
A BICO interconnection for a single PZD can only take place either on r2050 or r2060.
Note: IF1: Interface 1
Description: Connector output to interconnect PZD (setpoints) with word format received from the fieldbus controller.
Index: [0] = PZD 1
[1] = PZD 2
[2] = PZD 3
[3] = PZD 4
[4] = PZD 5
Note: IF1: Interface 1
Description: Selects the PZD (actual values) with word format to be sent to the fieldbus controller.
Index: [0] = PZD 1
[1] = PZD 2
[2] = PZD 3
[3] = PZD 4
[4] = PZD 5
[5] = PZD 6
[6] = PZD 7
[7] = PZD 8
[8] = PZD 9
[9] = PZD 10
[10] = PZD 11
[11] = PZD 12
[12] = PZD 13
[13] = PZD 14
[14] = PZD 15
[15] = PZD 16
[16] = PZD 17
[17] = PZD 18
[18] = PZD 19
[19] = PZD 20
[20] = PZD 21
[21] = PZD 22
[22] = PZD 23
[23] = PZD 24
[24] = PZD 25
Notice: The parameter may be protected as a result of p0922 or p2079 and cannot be changed.
Note: IF1: Interface 1
r2050[0...4] CO: IF1 PROFIdrive PZD receive word / IF1 PZD recv word
TM150, TM15DI_DO,
TM31
Can be changed: - Access level: 3
Data type: Integer16 Func. diagram: -
Min Max Factory setting
- - -
p2051[0...24] CI: IF1 PROFIdrive PZD send word / IF1 PZD send word
CU_DCP Can be changed: U, T Access level: 3
Data type: Unsigned32 / Integer16 Func. diagram: 2450, 2483
Min Max Factory setting
- - 0
Siemens Parts
To Next Page
Loading...
