Siemens sinamics dcp - r0949[0...63] Fault value; Fault value; p0952 Fault cases counter; Fault cases qty; r0963 PROFIBUS baud rate; PB baud rate; r0964[0...6] Device identification; Device ident

2 Parameters
2.2 List of parameters
SINAMICS DCP
54 List Manual (LH21), 05/2016
Description: Displays additional information about the fault that occurred (as integer number).
Dependency: Refer to: r0945, r0947, r0948, r2109, r2130, r2133, r2136, r3115, r3120, r3122
Note: The buffer parameters are cyclically updated in the background (refer to status signal in r2139).
The structure of the fault buffer and the assignment of the indices is shown in r0945.
Description: Number of fault situations that have occurred since the last reset.
Dependency: The fault buffer is deleted (cleared) by setting p0952 to 0.
Refer to: r0945, r0947, r0948, r0949, r2109, r2130, r2133, r2136
Description: Number of fault situations that have occurred since the last reset.
Dependency: The fault buffer is deleted (cleared) by setting p0952 to 0.
Refer to: r0945, r0947, r0948, r0949, r2109, r2130, r2133, r2136
Description: Displays the corresponding value for the PROFIBUS baud rate.
Value: 0: 9.6 kbit/s
1: 19.2 kbit/s
2: 93.75 kbit/s
3: 187.5 kbit/s
4: 500 kbit/s
6: 1.5 Mbit/s
7: 3 Mbit/s
8: 6 Mbit/s
9: 12 Mbit/s
10: 31.25 kbit/s
11: 45.45 kbit/s
255: Unknown
Description: Displays the device identification.
r0949[0...63] Fault value / Fault value
TM150, TM15DI_DO,
TM31
Can be changed: - Access level: 3
Data type: Integer32 Func. diagram: 8050, 8060
Min Max Factory setting
- - -
p0952 Fault cases counter / Fault cases qty
CU_DCP, DCP_CTRL Can be changed: U, T Access level: 3
Data type: Unsigned16 Func. diagram: 8060
Min Max Factory setting
0 65535 0
p0952 Fault cases counter / Fault cases qty
TM150, TM15DI_DO,
TM31
Can be changed: U, T Access level: 3
Data type: Unsigned16 Func. diagram: 6700, 8060
Min Max Factory setting
0 65535 0
r0963 PROFIBUS baud rate / PB baud rate
CU_DCP Can be changed: - Access level: 3
Data type: Unsigned16 Func. diagram: -
Min Max Factory setting
0 255 -
r0964[0...6] Device identification / Device ident
CU_DCP Can be changed: - Access level: 2
Data type: Unsigned16 Func. diagram: -
Min Max Factory setting
- - -