Siemens sinamics dcp - p0004 BOP display filter; BOP disp_filter; p0005[0...1] BOP operating display selection; BOP op_disp sel

2 Parameters
2.2 List of parameters
SINAMICS DCP
24 List Manual (LH21), 05/2016
Value: 1: Standard
2: Extended
3: Expert
4: Service
Note: A higher set access level also includes the lower one.
Access level 1 (standard):
Parameters for simplest possible operations.
Access level 2 (extended):
Parameters to operate the basic functions of the drive unit.
Access level 3 (experts):
Expert know-how is required for these parameters (e.g. BICO parameterization).
Access level 4 (service):
For these parameters, it is necessary that authorized service personnel enter the appropriate password (p3950).
Description: Sets the display filter for parameters with the Basic Operator Panel (BOP).
Value: 0: All parameters
1: Displays, signals
2: Power unit
3: Motor
4: Encoder/pos enc
5: Technology/units
7: Digital inputs/outputs, commands, sequence control
12: Functions
14: Control
15: Data sets
20: Communication
21: Faults, alarms, monitoring functions
28: Free function blocks
47: Trace and function generator
50: OA parameters
90: Topology
98: Command Data Sets (CDS)
99: Drive Data Sets (DDS)
Dependency: Refer to: p0003
Notice: The display filter via p0004 provides precise filtering and displays the corresponding parameters only when p0009
and p0010 = 0.
Note: The set access level via p0003 is also relevant for the display filter via p0004.
Examples (assumption: p0009 = p0010 = 0):
p0003 = 1, p0004 = 3
--> Only the parameters for the motor with access level 1 are displayed.
p0003 = 2, p0004 = 3
--> Only the parameters for the motor with access levels 1 and 2 are displayed.
Description: Sets the parameter number and parameter index for display for p0006 = 4 for the Basic Operator Panel (BOP).
Index: [0] = Parameter number
[1] = Parameter index
Dependency: Refer to: p0006
p0004 BOP display filter / BOP disp_filter
CU_DCP Can be changed: C2(1), U, T Access level: 1
Data type: Integer16 Func. diagram: -
Min Max Factory setting
0 99 0
p0005[0...1] BOP operating display selection / BOP op_disp sel
CU_DCP Can be changed: U, T Access level: 2
Data type: Unsigned16 Func. diagram: -
Min Max Factory setting
0 65535 [0] 2
[1] 0