Siemens sinamics dcp - p1000[0...n] Macro Connector Inputs (CI) for speed setpoints; Macro CI n_set; p1500[0...n] Macro Connector Inputs (CI) for torque setpoints; Macro CI M_set; p2006 Reference temp; Ref temp

2 Parameters
2.2 List of parameters
SINAMICS DCP
62 List Manual (LH21), 05/2016
Note: Modified parameters are displayed in indices 0 to 98. If an index contains the value 0, then the list ends here.
This list consists solely of the following parameters:
r0990[0...99], r0991[0...99] ... r0999[0...99]
The parameters in this list are not displayed in the expert list of the commissioning software. However, they can be
read from a higher-level control system (e.g. PROFIBUS master).
Description: Runs the corresponding macro files.
The Connector Inputs (CI) for the speed setpoints of the appropriate Command Data Set (CDS) are appropriately
interconnected.
The selected macro file must be available on the memory card/device memory.
Example:
p1000 = 6 --> the macro file PM000006.ACX is run.
Dependency: Refer to: p0015, p0700, p1500, r8572
Notice: No errors were issued during quick commissioning (p3900 = 1) when writing to parameters of the QUICK_IBN group!
When executing a specific macro, the corresponding programmed settings are made and become active.
Note: The macros in the specified directory are displayed in r8572. r8572 is not in the expert list of the commissioning
software.
Macros available as standard are described in the technical documentation of the particular product.
CI: Connector Input
Description: Runs the corresponding macro files.
The Connector Inputs (CI) for the torque setpoints of the appropriate Command Data Set (CDS) are appropriately
interconnected.
The selected macro file must be available on the memory card/device memory.
Example:
p1500 = 6 --> the macro file PM000006.ACX is run.
Dependency: Refer to: p0015, p0700, p1000, r8573
Notice: No errors were issued during quick commissioning (p3900 = 1) when writing to parameters of the QUICK_IBN group!
When executing a specific macro, the corresponding programmed settings are made and become active.
Note: The macros in the specified directory are displayed in r8573. r8573 is not in the expert list of the commissioning
software.
Macros available as standard are described in the technical documentation of the particular product.
CI: Connector Input
Description: Sets the reference quantity for temperature.
All temperatures specified as relative value are referred to this reference quantity.
The reference quantity corresponds to 100% or 4000 hex (word) or 4000 0000 hex (double word).
p1000[0...n] Macro Connector Inputs (CI) for speed setpoints / Macro CI n_set
DCP_CTRL Can be changed: C2(1), T Access level: 1
Data type: Unsigned32 Func. diagram: -
Min Max Factory setting
0 999999 0
p1500[0...n] Macro Connector Inputs (CI) for torque setpoints / Macro CI M_set
DCP_CTRL Can be changed: C2(1), T Access level: 1
Data type: Unsigned32 Func. diagram: -
Min Max Factory setting
0 999999 0
p2006 Reference temp / Ref temp
TM150, TM31 Can be changed: T Access level: 3
Data type: FloatingPoint32 Func. diagram: -
Min Max Factory setting
50.00 [°C] 300.00 [°C] 100.00 [°C]