Siemens sinamics dcp - p0006 BOP operating display mode; BOP op_ disp mode; p0007 BOP background lighting; BOP lighting; p0008 BOP drive object after booting; BOP DO after boot; p0009 Device commissioning parameter filter; Dev comm par_filt

2 Parameters
2.2 List of parameters
SINAMICS DCP
26 List Manual (LH21), 05/2016
Description: Sets the mode of the operating display for the Basic Operator Panel (BOP) in the operating states "ready for
operation" and "operation".
Value: 4: p0005
Dependency: Refer to: p0005
Note: Mode 4 is available for all drive objects.
Description: Sets the mode of the operating display for the Basic Operator Panel (BOP) in the operating states "ready for
operation" and "operation".
Value: 4: p0005
Dependency: Refer to: p0005
Note: Mode 0 ... 3 can only be selected if also r0020, r0021 are available on the drive object.
Mode 4 is available for all drive objects.
Description: Sets the delay time until the background lighting of the Basic Operator Panel (BOP) is switched off.
If no keys are actuated, then the background lighting automatically switches itself off after this time has expired.
Note: p0007 = 0: Background lighting is always switched on (factory setting).
Description: Sets the required drive object that is active at the Basic Operator Panel (BOP) after booting.
Note: The value from p0008 initializes the display on the Basic Operator Panel (BOP) at the top left after booting.
The drive object Control Unit is selected using the value 1.
Description: Sets the device and basic drive commissioning.
By appropriately setting this parameter, those parameters are filtered that can be written into in the various
commissioning steps.
Value: 0: Ready
1: Device configuration
2: Defining the drive type/function module
3: Drive base configuration
p0006 BOP operating display mode / BOP op_ disp mode
CU_DCP, DCP_CTRL Can be changed: U, T Access level: 3
Data type: Integer16 Func. diagram: -
Min Max Factory setting
4 4 4
p0006 BOP operating display mode / BOP op_ disp mode
TM150, TM15DI_DO,
TM31
Can be changed: U, T Access level: 3
Data type: Integer16 Func. diagram: -
Min Max Factory setting
4 4 4
p0007 BOP background lighting / BOP lighting
CU_DCP Can be changed: U, T Access level: 3
Data type: Unsigned32 Func. diagram: -
Min Max Factory setting
0 [s] 2000 [s] 0 [s]
p0008 BOP drive object after booting / BOP DO after boot
CU_DCP Can be changed: U, T Access level: 3
Data type: Unsigned16 Func. diagram: -
Min Max Factory setting
1 65535 2
p0009 Device commissioning parameter filter / Dev comm par_filt
CU_DCP Can be changed: C1, T Access level: 1
Data type: Integer16 Func. diagram: -
Min Max Factory setting
0 55 1