SINAMICS DCP
List Manual (LH21), 05/2016
213
2 Parameters
2.2 List of parameters
Note: r8889 together with p8880 to p8884 forms five binector-connector converters.
Description: Binector output for bit-serial interconnection of PZD1 (normally control word 1) received via interface 2.
Dependency: Refer to: r8850
Note: IF2: Interface 2
Description: Binector output for bit-serial interconnection of PZD2 received via interface 2.
Dependency: Refer to: r8850
Note: IF2: Interface 2
r8890.0...15 BO: IF2 PZD1 receive bit-serial / IF2 PZD1 recv bitw
DCP_CTRL, TM150,
TM15DI_DO, TM31
Can be changed: - Access level: 3
Data type: Unsigned16 Func. diagram: 2485, 2491,
9204, 9206
Min Max Factory setting
- - -
Bit field: Bit Signal name 1 signal 0 signal FP
00 Bit 0 ON OFF -
01 Bit 1 ON OFF -
02 Bit 2 ON OFF -
03 Bit 3 ON OFF -
04 Bit 4 ON OFF -
05 Bit 5 ON OFF -
06 Bit 6 ON OFF -
07 Bit 7 ON OFF -
08 Bit 8 ON OFF -
09 Bit 9 ON OFF -
10 Bit 10 ON OFF -
11 Bit 11 ON OFF -
12 Bit 12 ON OFF -
13 Bit 13 ON OFF -
14 Bit 14 ON OFF -
15 Bit 15 ON OFF -
r8891.0...15 BO: IF2 PZD2 receive bit-serial / IF2 PZD2 recv bitw
DCP_CTRL, TM150,
TM15DI_DO, TM31
Can be changed: - Access level: 3
Data type: Unsigned16 Func. diagram: 2485, 2491,
9204, 9206
Min Max Factory setting
- - -
Bit field: Bit Signal name 1 signal 0 signal FP
00 Bit 0 ON OFF -
01 Bit 1 ON OFF -
02 Bit 2 ON OFF -
03 Bit 3 ON OFF -
04 Bit 4 ON OFF -
05 Bit 5 ON OFF -
06 Bit 6 ON OFF -
07 Bit 7 ON OFF -
08 Bit 8 ON OFF -
09 Bit 9 ON OFF -
10 Bit 10 ON OFF -
11 Bit 11 ON OFF -
12 Bit 12 ON OFF -
13 Bit 13 ON OFF -
14 Bit 14 ON OFF -
15 Bit 15 ON OFF -
Siemens Parts
To Next Page
Loading...
