Siemens sinamics dcp - Page 75

SINAMICS DCP
List Manual (LH21), 05/2016
75
2 Parameters
2.2 List of parameters
[8] = PZD 9 + 10
[9] = PZD 10 + 11
[10] = PZD 11 + 12
[11] = PZD 12 + 13
[12] = PZD 13 + 14
[13] = PZD 14 + 15
[14] = PZD 15 + 16
[15] = PZD 16 + 17
[16] = PZD 17 + 18
[17] = PZD 18 + 19
[18] = PZD 19 + 20
[19] = PZD 20 + 21
[20] = PZD 21 + 22
[21] = PZD 22 + 23
[22] = PZD 23 + 24
[23] = PZD 24 + 25
[24] = PZD 25 + 26
[25] = PZD 26 + 27
[26] = PZD 27 + 28
[27] = PZD 28 + 29
[28] = PZD 29 + 30
[29] = PZD 30 + 31
[30] = PZD 31 + 32
[31] = PZD 32 + 33
[32] = PZD 33 + 34
[33] = PZD 34 + 35
[34] = PZD 35 + 36
[35] = PZD 36 + 37
[36] = PZD 37 + 38
[37] = PZD 38 + 39
[38] = PZD 39 + 40
[39] = PZD 40 + 41
[40] = PZD 41 + 42
[41] = PZD 42 + 43
[42] = PZD 43 + 44
[43] = PZD 44 + 45
[44] = PZD 45 + 46
[45] = PZD 46 + 47
[46] = PZD 47 + 48
[47] = PZD 48 + 49
[48] = PZD 49 + 50
[49] = PZD 50 + 51
[50] = PZD 51 + 52
[51] = PZD 52 + 53
[52] = PZD 53 + 54
[53] = PZD 54 + 55
[54] = PZD 55 + 56
[55] = PZD 56 + 57
[56] = PZD 57 + 58
[57] = PZD 58 + 59
[58] = PZD 59 + 60
[59] = PZD 60 + 61
[60] = PZD 61 + 62
[61] = PZD 62 + 63
[62] = PZD 63 + 64
Dependency: Refer to: r2050
Notice: Where there is a multiple interconnection of a connector output, all the connector inputs must either have Integer or
FloatingPoint data types.
A BICO interconnection for a single PZD can only take place either on r2050 or r2060.
A maximum of 4 indices of the "trace" function can be used.
Note: IF1: Interface 1
Siemens Parts