(7) Align the center of the seal sleeve with the center of the splice.
(8) Apply heat to shrink the seal sleeve into position.
(9) Push the shield tube to Cable B so that the forward end of the tube is against the end of the cable
jacket of Cable B.
(10) Attach the end of the shield tube to the shield of Cable B:
(a) Twist the end of the shield tube down so that the end of the tube is tight against the shield of
the cable.
(b) Push the solder sleeve toward the end of the cable until the rear edge of the solder ring is
0.10 inch from the end of the cable jacket.
(c) Apply heat to the center of the solder sleeve until the solder melts and flows into the shield
tube and the shield of the cable.
(11) Attach the remaining free end of the shield tube to the shield of the Cable A:
(a) Pull the shield tube across the splice so that it is tight.
(b) Remove the length of the shield tube that makes an overlap with the end of the outer jacket
of the Cable A.
(c) Do Step 16.B.(10) again.
(12) Align the center of the outer sleeve with the center of the seal sleeve.
NOTE: On each end of the splice assembly, the outer sleeve should make approximately a 1.0
inch overlap with the cable jacket.
(13) To shrink the outer sleeve into position:
(a) Apply heat from the center of the sleeve toward one end of the sleeve until the longitudinal
line cannot be seen.
(b) Apply heat from the center of the sleeve toward the other end of the sleeve until the
longitudinal line cannot be seen.
ASSEMBLY OF SPLICES
707, 727-787
STANDARD WIRING PRACTICES MANUAL
20-30-12
Page 339
Jun 15/2021D6-54446
ECCN 9E991 BOEING PROPRIETARY - See title page for details
To Next Page
Loading...
