Send document comments to nexus7k-feedback-doc@cisco.com
2-144
Cisco NX-OS System Messages Reference
OL-15994-03
Chapter 2 System Messages and Recovery Procedures
EIGRP Messages
Error Message EIGRP-3-MTSRECV Format: MTS receive failed on %s queue: %s
Explanation EIGRP_EXPL_UNEXPECTED_EVENT
Parameters: Queue name, Error ...
Recommended Action No action is required.
Error Message EIGRP-3-MTSSEND Format: MTS send() error to SAP %d, opcode %d: %s
Explanation EIGRP_EXPL_UNEXPECTED_EVENT
Parameters: MTS SAP, MTS Opcode, Error ...
Recommended Action Contact the Cisco Technical Assistance Center (TAC) through the Cisco
Support web site http://www.cisco.com/tac.
Error Message EIGRP-3-MULTIFLOW_DUAL Format: Flow control error, %s, on %s
Explanation A software or hardware error occurred.
Parameters: Error description, Interface ...
Recommended Action EIGRP process still operational. Send the error log message and the running
configuration to the Cisco Technical Assistance Center (TAC) through the Cisco Support web site
http://www.cisco.com/tac.
Error Message EIGRP-3-NOHANDLE_DUAL Format: Handle %d is not allocated in pool.
Explanation A software or hardware error occurred.
Parameters: Peer handle ...
Recommended Action EIGRP process still operational. Send the error log message and the running
configuration to the Cisco Technical Assistance Center (TAC) through the Cisco Support web site
http://www.cisco.com/tac.
Error Message EIGRP-3-PEERSEXIST_DUAL Format: %d peers exist on IIDB %s
Explanation A software or hardware error occurred.
Parameters: Peer count, Interface ...
Recommended Action EIGRP process still operational. Send the error log message and the running
configuration to the Cisco Technical Assistance Center (TAC) through the Cisco Support web site
http://www.cisco.com/tac.
Error Message EIGRP-3-PFXLIMIT_DUAL Format: %s %d %s prefix limit exceeded
Explanation Prefix limit threshold exceeded.
Parameters: DUAL descriptor block name, Autonomous system number, Prefix type ...
Recommended Action EIGRP process still operational. Send the error log message and the running
configuration to the Cisco Technical Assistance Center (TAC) through the Cisco Support web site
http://www.cisco.com/tac.
To Next Page
Loading...
Need help?
General
