Send document comments to nexus7k-feedback-doc@cisco.com
2-287
Cisco NX-OS System Messages Reference
OL-15994-03
Chapter 2 System Messages and Recovery Procedures
IPS Messages
Error Message IPS-3-ISLB_ZONE_NO_ACTIVE_ZONESET: iSLB zonset activation returned
[hex] for VSAN [dec]
Explanation ISLB zone set activation failed. No active zone set.
Recommended Action Activate a zone set in the specified VSAN and retry.
IPS-4
Error Message IPS-4-FCIP_FTA_CFG_MISMATCH: [chars]: Mismatch in FCIP Ficon Tape
Acceleration configuration with peer
Explanation The FCIP Ficon Tape Acceleration configuration does not match with peer's
configuration.
Recommended Action Fix the FCIP Ficon Tape Acceleration configuration to be consistent with the
peer.
Error Message IPS-4-FCIP_FTA_VSAN_UPDATE_WARNING: FCIP FICON tape acceleration VSAN
update had an error ([chars]) on interface [chars] causing a flap of the interface
Explanation The FCIP FICON tape acceleration VSAN configuration experienced an error when
disabling and enabling the VSAN over the FCIP tunnel. The FCIP tunnel was disabled and reenabled
as a result of this error to ensure data integrity.
Recommended Action No action is required.
Error Message IPS-4-FCIP_LICENSE_BIND_FAILED: Bind failed for [chars] due to
[chars] for license failure; configuration accepted but bind failed
Explanation The FCIP configuration was accepted, but the FCIP interface did not bind to a physical
interface because the appropriate license was not available. If a license becomes available in the
future, this FCIP interface will bind to a physical interface automatically.
Recommended Action Check the license state with show license usage and acquire the necessary
FCIP license.
IPS-5
Error Message IPS-5-FCIP_BIND_FAILED: Bind failed for [chars] due to [chars] for
[chars]
Explanation FCIP/ISCSI Interface bind to Ethernet port failed.
Recommended Action No action is required.
To Next Page
Loading...
Need help?
General
