Send document comments to nexus7k-feedback-doc@cisco.com
2-438
Cisco NX-OS System Messages Reference
OL-15994-03
Chapter 2 System Messages and Recovery Procedures
OSPF Messages
Error Message OSPF-4-REDIST_MAX_PFX Format: Redistribution prefix limit has been
reached - %d prefixes
Explanation Check if redistRIBution of large number of prefixes is desired and has not been
configured by mistake
Parameters: Number of prefixes ...
Recommended Action No action is required.
Error Message OSPF-4-REDIST_THR_PFX Format: Redistribution prefix threshold has
been reached - %d prefixes
Explanation Check if redistRIBution of large number of prefixes is desired and has not been
configured by mistake
Parameters: Number of prefixes ...
Recommended Action No action is required.
Error Message OSPF-4-RESTART_SHUTDOWN Format: OSPF shutting self down via restart
command
Explanation OSPF process is shutting itself down due to the restart command.
Recommended Action No action is required.
Error Message OSPF-4-SELF_LSA Format: context %s: %s
Explanation Router received a newer copy of an LSA generated by itself. Two routers may be
configured with the same router ID or a router which was disconnected from the network has come
back.
Parameters: Context, Message ...
Recommended Action Verify if the router ID for the router is unique in the network.
Error Message OSPF-4-SOURCE_ERR Format: Bad source address %s - ours on %s
Explanation A OSPF packet with our own source address was received
Parameters: IP address, Interface name ...
Recommended Action No action is required.
Error Message OSPF-4-SRC_INVALID Format: Invalid src address %s, should not be seen
on %s
Explanation A OSPF packet packet with source address not on this network was received
Parameters: Source IP address, Interface name ...
Recommended Action No action is required.
To Next Page
Loading...
Need help?
General
