Cisco AP775A - Nexus Converged Network Switch 5010 Reference

Send document comments to nexus7k-feedback-doc@cisco.com
2-439
Cisco NX-OS System Messages Reference
OL-15994-03
Chapter 2 System Messages and Recovery Procedures
OSPF Messages
Error Message OSPF-4-SRC_MCAST Format: Bad source address %s - multicast on %s
Explanation A OSPFv3 packet with muticast source address was received
Parameters: Source IP address ...
Recommended Action No action is required.
Error Message OSPF-4-VERSION_ERR Format: Bad ospf version %d received from %s on %s
Explanation A OSPF packet with incorrect version number was received
Parameters: Version number, Source IP address, Interface name ...
Recommended Action No action is required.
Error Message OSPF-4-WRONGQ Format: Found wrong type of packet (%d) on internal %s
queue
Explanation Did not expect the specified packet type on the given incoming message queue
Parameters: Packet Type, Queue ...
Recommended Action No action is required.
OSPF-5
Error Message OSPF-5-ADJCHANGE Format: Nbr %s on %s went %s
Explanation An OSPF neighborship has just been established. Or a neighborship has just been
shutdown.
Parameters: Neighbor Id, Interface Id, New State ...
Recommended Action No action is required.
Error Message OSPF-5-NBRSTATE Format: Process %s, Nbr %s on %s from %s to %s, %s
Explanation The system has detected an error.
Parameters: Process tag, Neighbor Id, Interface Id, Old State, New State, Event ... Explanation: An
OSPF neighbor has just changed its state.
Recommended Action No action is required.

Cisco AP775A - Nexus Converged Network Switch 5010 Specifications

General

Brand	Cisco
Model	AP775A - Nexus Converged Network Switch 5010
Category	Switch
Language	English