Send document comments to nexus7k-feedback-doc@cisco.com
2-452
Cisco NX-OS System Messages Reference
OL-15994-03
Chapter 2 System Messages and Recovery Procedures
PIM Messages
Error Message PIM-3-SETSOCKOPT Format: setsockopt() on %s failed: %s
Explanation PIM failed in UDP socket operation. Auto-RP will not work.
Parameters: Message String Error String ...
Recommended Action Dump core, and and and then restart component.
Error Message PIM-3-SETUP_ROUTE Format: Couldn't setup PIM route %s in %s
Explanation PIM failed to install route in the local route-table.
Parameters: Address, Function Name ...
Recommended Action No action is required.
Error Message PIM-3-SHARED_DB_PUB_INIT Format: Could not do shared database
publisher initialization for interfaces rc=0x%x [%s]
Explanation The system is unable to do shared db publisher initialization
Parameters: Status Error, Syserror string ...
Recommended Action Dump core, and and and then restart component.
Error Message PIM-3-SHUTDOWN_FM Format: FM could not shut down PIM process
Explanation FM could not shut down PIM process.
Recommended Action Dump core, and and and then restart component.
Error Message PIM-3-SLAB_ALLOC Format: Slab alloc of type %s failed in %s
Explanation PIM process failed to allocate Slab memory.
Parameters: Structure Type, Function Name ...
Recommended Action Configure the network or router to decrease the number of routes.
Error Message PIM-3-SLAB_CREATE Format: Slab alloc of type %s failed
Explanation PIM process failed to allocate Slab memory.
Parameters: Structure Type ...
Recommended Action Configure the network or router to decrease the number of routes.
Error Message PIM-3-SM_CREATE Format: Couldn't create shm segment %s
Explanation PIM process failed to initialize shared memory resource.
Parameters: Shared Memory Segment Name ...
Recommended Action Dump core, and and and then restart component.
To Next Page
Loading...
Need help?
General
