Cisco AP775A - Nexus Converged Network Switch 5010 Reference

Send document comments to nexus7k-feedback-doc@cisco.com
2-463
Cisco NX-OS System Messages Reference
OL-15994-03
Chapter 2 System Messages and Recovery Procedures
PIM6 Messages
Error Message PIM6-3-MTSOPEN Format: Couldn't open %s mts-q: %s
Explanation PIM6 failed to open the MTS-queue resource.
Parameters: MSG Queue Name, Error String ...
Recommended Action Dump core, and and and then restart component.
Error Message PIM6-3-MUTEX_INIT Format: Couldn't init mutex %s
Explanation PIM6 process failed to initialize the mutex system resource.
Parameters: Thread Name ...
Recommended Action Dump core, and and and then restart component.
Error Message PIM6-3-NO_SET_PRIORITY Format: Failed to set policy or priority
Explanation PIM6 process could not set itself process priority, exiting.
Recommended Action No action is required.
Error Message PIM6-3-OPCODE_REG Format: Could not register opcode 0x%x, reason %s
Explanation The system is unable to register opcodes
Parameters: MTS Opcode, Error string ...
Recommended Action Dump core, and and and then restart component.
Error Message PIM6-3-PIM6_API_NOT_INIT Format: PIM6 API not initialized
Explanation PIM6 API is not initialized.
Parameters: Thread Name ...
Recommended Action No action is required.
Error Message PIM6-3-PIM6_CIB Format: Couldn't find PIM6 VRF for %s
Explanation PIM6 failed to obtain its VRF information block.
Recommended Action Dump core, and and and then restart component.
Error Message PIM6-3-PIM6_EXISTS Format: PIM6 is already running, process exiting
Explanation Another PIM6 process is already running, this process will shut down.
Recommended Action No action is required.

Cisco AP775A - Nexus Converged Network Switch 5010 Specifications

General

Brand	Cisco
Model	AP775A - Nexus Converged Network Switch 5010
Category	Switch
Language	English