Send document comments to nexus7k-feedback-doc@cisco.com
2-508
Cisco NX-OS System Messages Reference
OL-15994-03
Chapter 2 System Messages and Recovery Procedures
PORT Messages
Error Message PORT-5-IF_DOWN_DPVM_VSAN_SUSPENDED: Interface [chars] is down
(dynamic vsan in suspended state)
Explanation The specified dynamic VSAN is in suspended state.
Recommended Action Un-suspend the dynamic VSAN.
Error Message PORT-5-IF_DOWN_ELP_FAILURE_ISOLATION: Interface [chars] is down
(Isolation due to ELP failure)
Explanation ELP failed on the interface.
Recommended Action Check the output of 'show port internal info' in the 'ELP failure reason' field.
Error Message PORT-5-IF_DOWN_ELP_FAILURE_ISOLATION_CLASSF_PARAM_ERR: Interface
[chars] is down (Isolation due to ELP failure: class F param error)
Explanation ELP failed on the interface due to class F param error.
Recommended Action Configure the attached switchport correctly and try again.
Error Message PORT-5-IF_DOWN_ELP_FAILURE_ISOLATION_CLASSN_PARAM_ERR: Interface
[chars] is down (Isolation due to ELP failure: class N param error)
Explanation ELP failed on the interface due to class N param error.
Recommended Action Configure the attached switchport correctly and try again.
Error Message PORT-5-IF_DOWN_ELP_FAILURE_ISOLATION_INVALID_PAYLOAD_SIZE: Interface
[chars] is down (Isolation due to ELP failure: invalid payload size)
Explanation ELP failed on the interface due to invalid payload size.
Recommended Action Configure the attached switchport correctly and try again.
Error Message PORT-5-IF_DOWN_ELP_FAILURE_ISOLATION_INVALID_PORT_NAME: Interface
[chars] is down (Isolation due to ELP failure: invalid port name)
Explanation ELP failed on the interface due to invalid port name.
Recommended Action Configure the attached switchport correctly and try again.
Error Message PORT-5-IF_DOWN_ELP_FAILURE_ISOLATION_INVALID_SWITCH_NAME: Interface
[chars] is down (Isolation due to ELP failure: invalid switch name)
Explanation ELP failed on the interface due to invalid switch name.
Recommended Action Configure the attached switchport correctly and try again.