EasyManuals Logo

Cisco AP775A - Nexus Converged Network Switch 5010 Reference

Cisco AP775A - Nexus Converged Network Switch 5010
886 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #661 background imageLoading...
Page #661 background image
Send document comments to nexus7k-feedback-doc@cisco.com
2-623
Cisco NX-OS System Messages Reference
OL-15994-03
Chapter 2 System Messages and Recovery Procedures
STP Messages
Error Message STP-2-SET_PORT_STATE_FAIL: Port state change req to PIXM failed,
status = [hex] [[chars]] vdc [dec], tree id [dec], num ports [dec], ports [chars]
state [chars], opcode [chars], msg id ([dec]), rr_token [hex]
Explanation The port set port state hasfailed. Checkthe port.
Recommended Action No user action is required.
Error Message STP-2-SET_PORT_STATE_TIMEOUT: Port state change req to PIXM timedout
after [dec] sec. vdc [dec], tree id [dec], num ports [dec], ports [chars] state
[chars], opcode [chars], msg id ([dec]), rr_token [hex]
Explanation The port set port state has timed outCheck the port.
Recommended Action No user action is required.
Error Message STP-2-STP_INIT: STP initialization of [chars] [chars]
Explanation STP initialization has failed.
Recommended Action Contact the Cisco Technical Assistance Center (TAC) through the Cisco
Support web site http://www.cisco.com/tac.
Error Message STP-2-STP_ISSU_LC_RESET: STP resetting LC[dec] to prevent Loops
during ISSU caused by a topology change in the network. Peer on [chars] [chars]
could not be Disputed
Explanation This can happen as a result of a topology change in the network while the Linecard was
undergoing ISSU. Since STP cannot change the port state to blocking on the Linecard undergoing
ISSU, it will first try to prevent the Loop by causing a Dispute on the peer ports forcing them into
blocking state. But if the peer does not support Dispute mechanism, and STP detects a potential
Loop, it will reset the Linecard to prevent the Loop.
Recommended Action No user action is required.
Error Message STP-2-UNBLOCK_CONSIST_PORT: Unblocking port [chars] on [chars]. Port
consistency restored.
Explanation The Port VLAN ID and/or Port Type inconsistencies have been resolved and spanning
tree will now unblock the listed interface of the listed spanning tree instance as appropriate.
Recommended Action No user action is required.
Error Message STP-2-UNBLOCK_DETECTED_PVST_PEER: Unblocking port [chars] [PVST peer
detected].
Explanation The listed interface has stopped receiving SSTP BPDUs and so will be restored to
normal spanning tree state.
Recommended Action No user action is required.

Table of Contents

Other manuals for Cisco AP775A - Nexus Converged Network Switch 5010

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Cisco AP775A - Nexus Converged Network Switch 5010 and is the answer not in the manual?

Cisco AP775A - Nexus Converged Network Switch 5010 Specifications

General IconGeneral
BrandCisco
ModelAP775A - Nexus Converged Network Switch 5010
CategorySwitch
LanguageEnglish

Related product manuals