EasyManuals Logo

Cisco AP775A - Nexus Converged Network Switch 5010 Reference

Cisco AP775A - Nexus Converged Network Switch 5010
886 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #662 background imageLoading...
Page #662 background image
Send document comments to nexus7k-feedback-doc@cisco.com
2-624
Cisco NX-OS System Messages Reference
OL-15994-03
Chapter 2 System Messages and Recovery Procedures
STP Messages
Error Message STP-2-VLAN_PORT_LIMIT_EXCEEDED: The number of vlan-port instances
exceeded [[chars] mode] recommended limit of [dec]
Explanation The total number of individual VLAN ports, in the spanning tree mode specified in the
error message, has exceeded the limit specified in the error message. VLANs can be counted more
than once; if VLAN 1 is carried on 10 interfaces, it will count as 10 VLAN ports. Note that bundling
is igored for purposes of this count; if 8 interfaces on the same module are in one bundle, and the
port channel is carrying VLAN 1, it will count as 1 VLAN ports.
Recommended Action Reduce the number of trunks and VLANs configured in the switch. Keep the
VLAN port count below the recommended limit specified in the configuration documentation. Enter
the <CmdBold>show interface trunk<NoCmdBold> command to see the total number of trunks and
VLANs.
Error Message STP-2-VPC_PEER_LINK_INCONSIST_BLOCK: vPC peer-link detected [chars]
blocking [chars] [chars].
Explanation VPC Peer-link detected the STP inconsistency mentioned in the message. This will
impact the STP topology for vPCs and can cause frame duplications. As a result, the interface was
moved to the spanning tree Blocking state.
Recommended Action No user action is required.
Error Message STP-2-VPC_PEER_LINK_INCONSIST_ERRDISABLE: vPC Peer-link detected
[chars]. Disabling [chars].
Explanation VPC Peer-link detected the STP inconsistency mentioned in the message. This will
impact the STP topology for vPCs and can cause frame duplications. As a result, the vPC Peer-link
was administatively shut down.
Recommended Action Resolve the inconsistency reported in this message on the vPC Peer link. After
the conflict has been resolved, re-enable the interface by entering the <CmdBold>no
shutdown<NoCmdBold> command in interface configuration mode.
Error Message STP-2-VPC_PEER_LINK_INCONSIST_UNBLOCK: vPC peer-link inconsistency
cleared unblocking [chars] [chars].
Explanation VPC Peer-link inconsistency is cleared and the vPC interface listed in the message has
been restoredddd to normal spanning tree state.
Recommended Action No user action is required.

Table of Contents

Other manuals for Cisco AP775A - Nexus Converged Network Switch 5010

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Cisco AP775A - Nexus Converged Network Switch 5010 and is the answer not in the manual?

Cisco AP775A - Nexus Converged Network Switch 5010 Specifications

General IconGeneral
BrandCisco
ModelAP775A - Nexus Converged Network Switch 5010
CategorySwitch
LanguageEnglish

Related product manuals