Send document comments to nexus7k-feedback-doc@cisco.com
2-30
Cisco NX-OS System Messages Reference
OL-15994-03
Chapter 2 System Messages and Recovery Procedures
ARP Messages
Error Message ARP-2-SYSMGR_UUID Format: Failed to get uuid from sysmgr during %s
Explanation An unrecoverable software error has occurred during ARP initialization.
Recommended Action Use 'reload' command to reload the system. Be aware that this problem affects
all VDCs on the system.
Error Message ARP-2-THR_CREAT Format: Failed to create thread %s: error %d
Explanation An unrecoverable software error has occurred during ARP initialization.
Recommended Action Use 'reload' command to reload the system. Be aware that this problem affects
all VDCs on the system.
Error Message ARP-2-THREAD_FAIL Format: Failed to start %s thread
Explanation An unrecoverable software error has occurred during ARP initialization.
Recommended Action Use 'reload' command to reload the system. Be aware that this problem affects
all VDCs on the system.
Error Message ARP-2-TIMER_SET Format: Failed to initialize new timer set
Explanation An unrecoverable software error has occurred during ARP initialization.
Recommended Action Use 'reload' command to reload the system. Be aware that this problem affects
all VDCs on the system.
Error Message ARP-2-TIMERS_INIT Format: Failed to initialize timers
Explanation An unrecoverable software error has occurred during ARP initialization.
Recommended Action Use 'reload' command to reload the system. Be aware that this problem affects
all VDCs on the system.
ARP-3
Error Message ARP-3-ADJ_ADD Format: Failed to add adjacency for received packet from
%s on %s
Explanation Due to this failure, packet forwarding to this address will be affected until the next
successful retry.
Recommended Action No action is required.
To Next Page
Loading...
Need help?
General
