Send document comments to nexus7k-feedback-doc@cisco.com
2-642
Cisco NX-OS System Messages Reference
OL-15994-03
Chapter 2 System Messages and Recovery Procedures
SVC Messages
Error Message SVC-3-SVC_SYSLOG_IF_INTERNAL_ERROR: Interface [chars] internal error:
[chars]
Explanation SVC interface internal error.
Recommended Action No action is required.
Error Message SVC-3-SVC_SYSLOG_LC_INTERNAL_ERROR: Unable to send MTS to linecard in
slot [dec]: [chars]
Explanation Linecard MTS failure.
Recommended Action No action is required.
Error Message SVC-3-SVC_SYSLOG_NPORT_INTERNAL_ERROR: [chars] N-port for Interface
[chars], vsan [dec] internal error: [chars]
Explanation N-port internal error.
Recommended Action No action is required.
SVC-4
Error Message SVC-4-NODE_WARNING_MSG: (SVC [dec]/[dec]
SS_EID_CA_EV_FIRST_DATA_PINNED ) Customer data pinned [chars]
Explanation There is now pinned customer data. This warning is given when data is pinned and there
wasn't already pinned data. Error log entries will exist for the underlying cause of the pinned data.
Recommended Action Perform problem determintation on the error log to determine the cause of the
pinned data and correct.
Error Message SVC-4-NODE_WARNING_MSG: (SVC [dec]/[dec]
SS_EID_CA_EV_HWS_TO_SYNCHRONOUS ) Cache in write through mode due to pinned data
[chars]
Explanation The cache must now operate in write through mode because of the amount of pinned
data.
Recommended Action Perform problem determintation on the error log to determine the cause of the
pinned data and correct.