Send document comments to nexus7k-feedback-doc@cisco.com
2-647
Cisco NX-OS System Messages Reference
OL-15994-03
Chapter 2 System Messages and Recovery Procedures
SVC Messages
Error Message SVC-4-NODE_WARNING_MSG: (SVC [dec]/[dec]
SS_EID_IC_ER_DIRECTORY_LIST_FAILED ) Failed to obtain directory listing from
remote node [chars]
Explanation An attempt to clean or retrieve files from /dumps directory has failed because of a
failure to get listing of the directory from the remote node.
Recommended Action Determine if the remote node is still online. If not, perform problem
determination on the remote node. If it is, retry the command. If it still fails contact the Cisco
Technical Assistance Center (TAC) through the Cisco Support web site http://www.cisco.com/tac.
Cisco commands may be used to access the node directly as an alternative.
Error Message SVC-4-NODE_WARNING_MSG: (SVC [dec]/[dec]
SS_EID_IC_ER_FEATURISATION_VIOLATION ) Featurisation violation [chars]
Explanation The user has allocated more virtualized storage than licensed for or established a Flash
Copy mapping or Remote Copy relationship when these have not been licensed.
Recommended Action Look in the feature log for log entries of type 'Error' to determine the type of
violation. The user then should then either reduce virtualized storage, remove the Flash Copy
mapping or Remote Copy relationship, so as to be in compliance with their license; or update the
license information if that is incorrect; or arrange with their IBM representative to purchase a license
for the desired features.
Error Message SVC-4-NODE_WARNING_MSG: (SVC [dec]/[dec]
SS_EID_IC_ER_TRANSFER_FILE_FAILED ) Failed to transfer file from remote node
[chars]
Explanation An attempt to retrieve a file from /dumps directory has failed.
Recommended Action Determine if the remote node is still online. If not, perform problem
determination on the remote node. If it is, retry the command. If it still fails contact the Cisco
Technical Assistance Center (TAC) through the Cisco Support web site http://www.cisco.com/tac.
Cisco commands may be used to access the node directly as an alternative.
Error Message SVC-4-NODE_WARNING_MSG: (SVC [dec]/[dec] SS_EID_IC_EV_IOGRP_NONE_OK
) Both nodes in the IO group are not available [chars]
Explanation Following node remove by the user, there are no nodes left in the IO group.
Recommended Action Contact the Cisco Technical Assistance Center (TAC) through the Cisco
Support web site http://www.cisco.com/tac.
Error Message SVC-4-NODE_WARNING_MSG: (SVC [dec]/[dec]
SS_EID_IC_EV_UPGRADE_NODE_PENDED ) Software upgrade process failed [chars]
Explanation A software upgrade has failed. This might be because of a hardware error or it might
be because of a failure in the new version of the software. An automatic software downgrade is
performed to restore the nodes to their previous software version. This will be indicated in the log
by a 'Software downgrade complete' entry. If the downgrade operation fails to downgrade a node,
for example because it is offline, the download operation will stop and wait for the offline SAN
To Next Page
Loading...
Need help?
General
